It is a white cement-based, single-component, polymer-added powder mortar with extra properties, with reduced slip properties and a long working time, used for bonding tiles and ceramics. 

Usage areas:

•Indoors and outdoors,

•On horizontal and vertical surfaces,

It is used for bonding small and medium sized floor and wall ceramics, mosaics and similar materials with a water absorption rate above 3% .

Advantages:

•Easy to apply.

•It is decorative due to its white color.

•Since it is the same color as the white joint, the joint application can be started in a shorter time.

•Processing time is long, saving time and labor.

•It allows the glued plates to be corrected for a long time.

•It is resistant to water and frost.

•Provides high stability and does not sag in vertical applications.

Preparation of the Surface:

•Make sure that the application surface is cured.

•The application surface must be clean of anti-adhesion substances such as dust, oil, tar, pitch, paint, silicone, curing material, detergent and mold oils.

•Defects on the application surface should be corrected with suitable DEMAFIX repair mortars 24 hours before, depending on the depth and structure of the surface.

•The application surface should be wetted and kept moist. If the surface is very water absorbent, apply a primer to the surface.

Application should be made after withdrawal .

•Before using ceramic adhesive in wet area applications, DEMAFİX must be applied for proper waterproofing.

Waterproofing should be applied with materials .

Preparation of Mortar:

•25 kg DEMAFIX Tile and Ceramic Adhesive Mortar (White) is added to approximately 6 - 7 liters of clean water and mixed preferably with a low-speed mixer until there are no lumps.

•The prepared mortar is left to mature for 5 - 10 minutes and used again by mixing for 1 - 2 minutes.

•The mixture in the container should be consumed within 2 - 2.5 hours. 

Application Information:

•First of all, a contact layer is formed by pressing the adhesive mortar strongly onto the application surface, and then the product is notched with a notched trowel selected according to the size of the tile.

must be in contact with at least 80% of the back side of the ceramic.

•Depending on the floor slabs used and the smoothness of the floor, if necessary, a double-sided adhesion method should be preferred and adhesive mortar should be applied to both the back of the ceramic and the surface and the combing direction should be applied.

The plates must be fixed perpendicular to each other .

•To ensure good adhesion, the ceramic is adhered to the surface by applying force with a rubber-tipped mallet.

must be provided .

•To ensure stronger adhesion in outdoor applications, by mixing with DEMAFIX LATEX or DEMAFIX DOUBLE COMPONENT ELASTIC INSULATION MATERIAL Component B in sufficient amount.

application should be made.

•By leaving a joint space compatible with the ceramic size and using the appropriate DEMAFIX joint filling material.

The application must be completed.

Consumption:

3.5 - 4 kg/m2

Attention:

•Avoid application at temperatures below +5°C and above +35°C.

•Pay attention to the amount of water added to the mortar. Do not add more water than necessary.

•In areas that are frozen, at risk of freezing within 24 hours, or exposed to direct sun and wind

application .

•Never add water or powder to expired mortar.

PACKAGING:

25 kg craft bags

Shelf life:

12 months on a pallet in a 10-layer stack in a moisture-free environment and in its unopened packaging.

can be stored .

Health and Safety:

As with all chemical products, food products, skin, eyes and mouth may be contaminated during use and storage.

contacted . During application, wear work clothes and protective clothing in accordance with occupational and worker health rules.

Gloves , glasses and mask should be used. If swallowed by accident, consult a doctor. In contact with skin

plenty of water. It should be stored in places inaccessible to children.