Technical Features: |
|
Appearance : |
Gray colourful thick dust |
Dust Intensity : |
~ 1,55 kg/lt |
This mixed light Ratio: |
4.5 - 5 liters of water / 25 kg dust |
resting Time : |
5 - 10 minute |
Container Lifespan : |
~ 30 minute |
Application Temperature : |
+5°C ile +35°C between |
do n't stick Strength : |
≥ 0,8 N/mm2 (EN 1542) |
bending over Durability: |
≥ 5 N/mm2 (EN 196-1) |
pressure Durability : |
≥ 15 N/mm2 (EN 12190) |
Service Temperature : |
- 30°C / +80°C |
White cement based , single component , polymer reinforced fine aggregate , suitable for R2 class , repair and surface finish that provides smooth finishing on concrete surfaces . It is a correction fee.
Usage areas :
• Interior and exterior applications ,
• Horizontal and vertical applications ,
• Restorations
, • Repair of concrete and prefabricated concrete elements ,
• Correction of wall and ceiling plasters and repair
, • It is used to obtain a smooth and solid surface before painting , ceramic coating and insulation . It is suitable for static cracks up to 5 mm .
Advantages :
• It is decorative due to its white color .
• Does not cause leakage or dust formation.
• It can only be mixed with water and applied easily .
• It dries quickly allowing use in a short time.
• Its lining provides high adherence .
• It is resistant to water and the freeze - thaw cycle.
• It is produced with fiber reinforcement upon request .
Preparation of the surface :
• Care should be taken to ensure that the application surface is cured .
• The application surface must be cleaned of substances that prevent adhesion such as dust , oil , tar , pitch, paint, silicone , curing material , detergent and mold oils .
• The application surface should be wetted and kept moist .
Preparation of the mortar :
• 25 kg DEMAFIX REPAIR MORTAR ( White) is added to approximately 5.5 - 6.5 liters of clean water and mixed thoroughly, preferably with a low - speed mixer, until no lumps remain . It is s ̧ tired .
• The prepared mortar is left to mature for 5 - 10 minutes and is used by mixing again for 1 - 2 minutes .
• The mixture in the container should be consumed within 30 minutes .
Application Information
: • Repair mortar is applied to cracked and broken areas separated from the surface with the help of a trowel .
• It can be applied in thickness between 1 - 5 mm .
• After application , it is recommended to moisten the surface at regular intervals within 24 hours .
Consumption :
1.5 kg/m 2 ( for 1 mm thick person )
Attention:
• Avoid application at temperatures below +5 ° C and above +35 ° C.
• Avoid application in areas that are frozen , at risk of freezing within 24 hours , or exposed to direct sun and wind .
• Never add powder or water to expired mortar .
• After the application is completed , keep the surface moist until the mortar cures .
• It cannot be applied on plaster , ready - colored plaster , paint and exterior coatings .
PACKAGING:
In 25 kg craft bags
Shelf Life :
in moisture-free environments and in its unopened packaging on a pallet with a 10-layer stack for 12 months.
Health and Safety :
As with all chemical products, contact with food products , skin , eyes and mouth should not be avoided during use and storage . During the application , work clothes , protective gloves , glasses and masks that comply with work and worker health rules should be used . If swallowed by accident, seek medical advice . In case of contact with skin, wash with plenty of water . It should be stored in places where children cannot reach it .